my3AWDgst

What did you do last two weeks more like it...moving and organizing...no sleep or very few hours of sleep...

Thanks

I'll take that Mike :-)

Great update André:-) What's the part number on that hand brake trim?

I replaced them earlier today :-) No need to scale the Freon,pressure gauges are your best friend!

This A/C compressor had enough! I got good used one and I ordered front seal kit,front shim kit,pulley bearing,R12-R134 fittings,receiver dryer and I picked up oil and Freon yesterday.

Last few days were extremely tough on me,I worked long hours in my garage and it's been 108*F last few days. I got front suspension assembled and this car is finally on the ground. Never mind the bent hood prop,it appears that my friends meat hooks were resting on my hood which caused hood prop to bend.

Got these new roof rack bars from Mike Aube. They need to be powder coated as they do have some chips in end caps.

Thanks guise :-) This show was awesome! Can't wait to go again:-) I'll post few pictures later.

From 80's and 90's car show from few weeks ago.

Yeah 25 year rule sucks :-(

Looks great André and I love the tint!

I purchased a larger house,this one has three car garage,huge RV access and ton of room dor parking. And photo below is my wagon :-(

Oil change,A/C pulley bearing,right side inner C.V boot and full inspection. Next month is going to be hard on this old girl :-(

Sir bring your truck around.Okay ;-)

Instructions recommend having it mounted inside the car. I mounted mine next to A/C clutch relay on the left of steering column.

I'm not sure,I haven't opened the boxes yet :-) On the end something is better then nothing,I'm not happy paying about $45 each plus shipping from Europe. Hell it took me few years to track this down,I put too much effort in researching parts or HOW TO and not a lot 405 owners do so I'm on my own here.

I end up calling them and ordering directly from them. They shipped them out next day with FedEx.

This weekend I finally got tired of driving this car with out tachometer! I've called MSD to asked them if they produce tachometer interference that would work for my application and they suggested to visit Dakota Digital. After a brief conversation with D.D employee I was suggested to purchase SGI-8E. It took only one day for it to arrive and it's extremely easy to install and set up. I'm extremely happy and glad to say that my tachometer is functional now! This weekend I'll have it permanently mounted and calibrated.

They are made by company named Rockford front wheel drive C.V boots.

A box full of C.V boots :-)

Rear suspension and gas tank finished! I also set Nikola's 306 front shocks and 306 lowering springs for he's 405. Replaced he's C.V boots and axle shaft bearing.

And finally it's done,here are some fresh pictures. EVO 70mm and sensors worked out great. I relocated oil fill-PCV under intake manifold.

End up being wrong sway bar :-( it's about 3" too short and wrong angle. Gonna need to call Summit racing tomorrow. This is actually 3g rear sway bar with tubular upper and lower control arms. I had tubular toe arms made by Paul Volk and side control arm is tubular from factory.

I found this and I'd like to share it with the group. Cheers!