Johnny Posted September 28, 2008 Report Share Posted September 28, 2008 Does anyone know what the tolerance for the oil pump is? I would also like to know the torque for the bolts that hold it together. Quote Link to comment Share on other sites More sharing options...
V-M Posted September 30, 2008 Report Share Posted September 30, 2008 These are general measures not direct for this engine but same type and same sized ones. Gear - body 0.05 -> 0.15mm Gear - gear 0.10 -> 0.20mm Gear - cover 0.05 -> 0.10mm What torgue? Pump to block? -> 20Nm Or are u meaning oilpump cover? V-M Quote Link to comment Share on other sites More sharing options...
Johnny Posted September 30, 2008 Author Report Share Posted September 30, 2008 Thanks V-M! I would like to know the torque for the cover. And how do I measure the gear-cover clearance? Quote Link to comment Share on other sites More sharing options...
V-M Posted October 1, 2008 Report Share Posted October 1, 2008 Thanks V-M! I would like to know the torque for the cover. And how do I measure the gear-cover clearance? Thats easy, just put tight enough There is no torgue for them but its not much cause those are only 6mm bolts (if I remember right). Clean gear place, gears and cover. Place cover sideways top of gear so at you can slip those (0.1mm) plates between cover and gear. V-M Quote Link to comment Share on other sites More sharing options...
Johnny Posted October 2, 2008 Author Report Share Posted October 2, 2008 Ah, I see... Thanks alot V-M! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.