christophe4559

Done !

Perhaps but i do it, it's not difficult to made.

Thank you. My problem is on the right way in France because of you too ! http://club505.forumpro.fr/t5690p30-recherche-tige-de-poussee-embrayage#101576

ok i undertstand. then we have this manufact : http://www.rationalstock.fr/materiel/fr/coussinet-a-collerette-auto-lubrifiant-en-bronze-fritte/30051000002/0/

I found this http://www.michaud-chailly.fr/index.php?ent_id=1&cat_id=1&ni1_id=19&ni2_id=114&ni3_id=296&ni4_id=2114&csaction=site%2Fentite%2Fcatalogue%2Fdetail_technique_filtrer&ent_id=1&cat_id=1&ni1_id=19&ni2_id=114&ni3_id=296&ni4_id=2114&colonne=7&filtre=8 I'm going to make an outside threading 12 x 1.5

For sure ! But we shouldn't let a little area ?

Ok it's clear ! thank you so much. For the end of the rod i mean "machining a ball". So how tall is the busching rod ? his emplitude ?

okayyy ! So you use a new steel rod ! And how can you Manufacture the kneecap at the end ? My problem is in fact that i haven't the old busching rod ! I lose it ! And one more question 1/4 means 1.4 inch, then means 3.556 centimeter ?

Did you have the mensurations off the original pushing rod ? diamètre , tall , ....

Very good solution i try it soon , thank you Bean !

Merci ! Yes and Club 505 member.

Hy. Buy in 2012 at 161000 Km , today in 2016 she have 199488 Km. I drive her every day for all because it was my only car. But in the begining of 2015, i change of job and i have to make 2000 Km per month. So i couldn't maintenance the 505 without spend all my time on. I had to give her a new fonction : a week end car ! and it goes on like that ! Just 3 photos of my first one ( a 180Hp), saled since2010. Next the 160Hp.

I'm looking for the pushing rod. Placed between the foot pedal and theTransmitter(Issuer) of clutch. Thank you !

Hello sorry for sorrow. I'm looking for the pushing rod. Placed between the foot pedal and theTransmitter(Issuer) of clutch. Perhaps you have just a cable !! So i'm luckyless. Thank you !