Jump to content

xd2s injectors and components

Recommended Posts

I am looking to remove and clean out the injectors on my xd2s here in a few months but want to make sure there are no special gaskets or washers that will be needed . Going by the parts I see a washer and copper gasket, but what is the purpose of this washer? Copper gasket I can attempt to get a machine shop to duplicate some others as well for my TX and oil cooling lines since my pug has always had a bad habit of leaking everywhere and never had the time or resources to fiddle with that aspect. And to caveat off that, where might I find some of these monark nozzles as I have yet to find any complete injectors to replace mine with, I preferred to go that route but no body seems to have any so rebuilding the originals will be the game plan unless someone on here has a connection.

Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...