Jump to content

83pgo

Members
  • Content Count

    44
  • Joined

  • Last visited

Everything posted by 83pgo

  1. I recieved a digital copy from 10PARUE and will send it your way as well. Check your messages it will be in your inbox soon.
  2. whats the distance between the teeth, side to side and cross ways if you can get it? I got the part number you put in but just in case i cant find that, the dimensions should work as well.
  3. I am looking to remove and clean out the injectors on my xd2s here in a few months but want to make sure there are no special gaskets or washers that will be needed . Going by the parts I see a washer and copper gasket, but what is the purpose of this washer? Copper gasket I can attempt to get a machine shop to duplicate some others as well for my TX and oil cooling lines since my pug has always had a bad habit of leaking everywhere and never had the time or resources to fiddle with that aspect. And to caveat off that, where might I find some of these monark nozzles as I have yet to find any c
  4. Website is broken for now. You can still contact me for parts by phone or email. Miles Potter Western Hemispheres / Pieces International 150 W Lake Ave Watsonville CA 95076 tel: 831-786-9347 email: [email protected] They are still in business from the looks of it but the website is still down for an unstated reason.
  5. I'm not too sure if its been asked, but a good bit of the fluids my 505 takes can be a little trivial even when reading the owners manual. What type of fluid does the steering, coolant and transmission take thats available in the new world market in the US? And the ymm is a 1983 Pgo 505 w/xd2s in front of a 3hp22.
  6. Has anyone ever done a swap from the 3hp22 to a manual transmission on a 2.3TD? Im looking at either the ba10/5 or the upgraded ax15 from the jeep family. Itll be non-priority swap but just want to see if anyones done and what it would all involve as i just the manual transmissions in general. The extra pedal would be common sense and the slave cyl setup as well just not exactly sure where to look for all the pertinent information
  7. spoke too soon, it went right back down
  8. It just came back up, got bored, checked and it works again. I just hope it doesn't go down when I really need in about a year so I can replace both my struts. Ive been riding on a bad one for a while now then it really started clanking so I figured it'd be a good reason to park it in storage until I can get it fixed.
  9. What’s happened to western hemispheres? I’ve been trying to get onto their website and now it won’t load. Did they bring down the site due to lack of business or something?
  10. Does anyone have a parts manual for the 505td? Ill be spending a few pennies on western hemispheres hopefully in a few years and they go by peugeot part numbers so i was wondering if anyone had a spare manual they might want to sell or know where to get one.
  11. Where is a spot to hook up the boost line if anyone knows? I dont see a spot accessible unless im not looking hard enough, the line for the smoke adjustment isnt picking any boost up when i hooked it up last night.
  12. I have a bosch unit as far as i know. My question is where would it hook up looking at the injection pump?
  13. It donned on me as well. Seemed like it would but in the end it wouldn’t be doing anything but help the boost go the wrong way
  14. Would that assist with cold start to prevent holding the pedal down while turning it over? I work on military diesels but it’s a bit newer than mine and honestly is my first diesel POV. I understand most of the concepts but some of these on this car has thrown me a curve ball every now and then.
×
×
  • Create New...